REPLACEMENT REAR COMPARTMENT NO HOLES FOR LUGGAGE COVER

When the rear compartment lift panel inner cover is being replaced, the replacement panel will not have the holes or stiffener for the luggage shade cover. Following are the instructions on how to cut and drill the holes using the template provided (see Figure 1).

1. Remove cover panel compartment lift window inner.

2. Cut out slots by placing template exactly on center of cover panel compartment lift window inner panel as indicated in Figure 2.

3. Place stiffener, P/N 20341735, in proper location and drill two (2) 3.4mm diameter holes using existing holes in stiffener as template.

4. Pop rivet stiffener to cover panel in two (2) places to secure.

5. Reinstall cover assembly to its original position.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.