----------
Condensation/water in front park/turn lamps.
------
Water collects on fascia surface and enters lamp through lamp drain hole.
-----------
Notch fascia as outlined in the following procedure:
1. Remove front park/turn lanip as outlined in the the following procedure.
2. Using a small fine tooth hand saw, notch facia in lamp opening as shown in Figure 1.
3. Reinstall lamp.
4. Repeat for other side if necessary.
Use the most applicable Labour Operation and Time from the Canadian Labour Time Guide.
0299b/7
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.