GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1996 🢒 Camaro 🢒 Transmission/Transaxle 🢒 Manual Transmission - MM6 🢒 Control Assembly

Removal Procedure
  1. Remove the control lever boot assembly. Refer to Control Lever Boot Assembly .

    2. Object Number: 33332 Size: SH
  2. Remove four bolts.
  3. Remove the Control.

Installation Procedure
  1. Clean the old sealant from the extension housing and from the shift control sealing surfaces.

    2. Object Number: 33331 Size: SH
  2. Apply a continuous 3 mm (0.125 in) bead of RTV Sealant on the extension housing-to-shift control sealing surface. Use GM P/N 12345739 or the equivalent.

    3. Object Number: 33332 Size: SH
  3. Install the shift control.
  4. Install the four attaching bolts.

    5. Tighten
    Tighten the bolts to 18 N·m (13 lb ft).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the control lever boot assembly. Refer to Control Lever Boot Assembly .