For 1990-2009 cars only
Removal Procedure
- Remove the exhaust system.
- Remove the transmission oil pan and the filter. Refer to Automatic Transmission Fluid and Filter Replacement
- Remove the external wiring harness connector from the transmission pass-through connector. Squeeze the fore and aft flats on the connector in order to release the locking tabs and the pull connector.
- Remove the 1-2 accumulator cover bolts.
- Remove the 1-2 accumulator cover.
- Remove the 1-2 accumulator piston.
- Remove the 1-2 accumulator springs, and the oil ring seal.
- Disconnect the transmission pressure switch electrical connector.
- Disconnect the 1-2 shift solenoid electrical connector.
- Disconnect the 2-3 shift solenoid electrical connector.
- Disconnect the pressure control solenoid electrical connector.
- Disconnect the TCC control solenoid electrical connector.
- Disconnect the wiring harness and the solenoid electrical connector.
- Disconnect the 3-2 control solenoid electrical connector.
- Remove the pressure control solenoid retainer bolt.
- Remove the pressure control solenoid retainer.
- Remove the pressure control solenoid from the control valve body.
- Remove the TCC solenoid bolts.
- Remove the pass-through electrical connector from the transmission case.
- Remove the TCC solenoid with the wiring harness from the transmission case.
Installation Procedure
- Install the TCC solenoid with the wiring harness to the transmission case.
- Install the pass-through electrical connector to the transmission case.
- Install the TCC solenoid bolts.
- Install the pressure control solenoid to the control valve body.
- Install the pressure control solenoid retainer.
- Install the pressure control solenoid bolt.
- Connect the 3-2 control solenoid electrical connector.
- Connect the wiring harness and the solenoid electrical connector.
- Connect the TCC control solenoid electrical connector.
- Connect the pressure control solenoid electrical connector.
- Connect the 2-3 shift solenoid electrical connector.
- Connect the 1-2 shift solenoid electrical connector.
- Connect the transmission pressure switch electrical connector.
- Install the 1-2 accumulator piston to the accumulator cover. Install the piston legs facing toward the case.
- Install the 1-2 accumulator spring onto the piston.
- Install the 1-2 accumulator cover.
- Install the 1-2 accumulator cover bolts.
- Install the wiring harness connector to the transmission pass-through connector.
- Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement
- Install the exhaust system.
Tighten
| • | Tighten the TCC solenoid bolts to 11 N·m (97 lb in). |
| • | Tighten the pressure control solenoid bolt to 11 N·m (97 lb in). |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts/screws to 11 N·m (97 lb in).
