GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1997 🢒 Camaro 🢒 Transmission/Transaxle 🢒 Manual Transmission - M49 🢒 Backup Lamp Switch Replacement

Removal Procedure

    Object Number: 38205 Size: SH
  1. Disconnect the battery negative cable assembly from the battery negative terminal. Refer to

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

    in General Information.
  2. Raise the vehicle. Refer to General Vehicle Lifting and Jacking in General Information.
  3. Support the vehicle with safety stands.

    4. Object Number: 33339 Size: SH
  4. 5-Speed: Disconnect the backup lamp switch electrical connector.

    5. Object Number: 33340 Size: SH
  5. 5-Speed: Remove the backup lamp switch.

    6. Object Number: 33342 Size: SH
  6. 6-Speed: Disconnect the backup lamp switch electrical connector.

    7. Object Number: 33346 Size: SH
  7. 6-Speed: Remove the backup lamp switch.

Installation Procedure
  1. Apply pipe sealant with Teflon® to the threads of the backup lamp switch. Use GM P/N 1052080 or the equivalent.

    2. Object Number: 33340 Size: SH
  2. 5-Speed: Install the backup lamp switch.

    3. Tighten
    The backup lamp switch to 38 N·m (28 lb ft).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 33339 Size: SH
  3. 5-Speed: Connect the backup lamp switch electrical connector.
  4. Remove the safety stands.
  5. Lower the vehicle.

    6. Object Number: 33346 Size: SH
  6. 6-Speed: Install the backup lamp switch.

    7. Tighten
    The backup lamp switch to 20 N·m (15 lb ft).


    Object Number: 33342 Size: SH
  7. 6-Speed: Connect the backup lamp switch electrical connector.
  8. Remove the safety stands.
  9. Lower the vehicle.

    10. Object Number: 38205 Size: SH
  10. Connect the battery negative cable assembly to the battery negative terminal.

    11. Tighten
    Tighten the terminal bolt to 15 N·m (11 lb ft).