Removal Procedure
- Disconnect the battery negative cable
assembly from the battery negative terminal. Refer to
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
in General Information.
- Raise the vehicle. Refer to General Vehicle Lifting and Jacking
in General Information.
- Support the vehicle with safety stands.
- Disconnect the electrical connector from
the vehicle speed sensor assembly.
- Remove the following parts:
| 5.2. | The vehicle speed sensor |
| 5.3. | The speedometer driven gear |
Installation Procedure
- Install the following:
| 1.1. | The speedometer driven gear |
| 1.2. | A new O-ring seal on the vehicle speed sensor assembly |
| 1.3. | The vehicle speed sensor assembly |
Tighten
Tighten the bolt to 10 N·m (89 lb in).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the electrical connector on the
vehicle speed sensor assembly.
- Remove the safety stands.
- Lower the vehicle.
- Connect the battery negative cable assembly
to the battery negative terminal.
Tighten
Tighten the terminal bolt to 15 N·m (11 lb ft).
