Starter Replacement 5.7L V8

Important: This vehicle was designed for starter mounting without shims. However, if single or double shims have been added to correct a noise or engagement condition, reinstall the shims in their original location to ensure proper pinion-to-flywheel engagement.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the left side oxidation catalytic converter. Refer to Oxidation Catalytic Converter Replacement

in Engine Exhaust.




3. Remove the starter motor bolts.
4. Lower the starter motor.



5. Remove the engine wiring harness starter lead nut.



6. Remove the positive battery cable to starter motor nut (3).
7. Remove the starter motor.

1. Install the starter motor.
2. Install the positive battery cable to starter motor nut (3).

Tighten
Tighten the positive battery cable to starter motor nut (3) to 10 N·m (89 lb in).




3. Install the engine wiring harness starter lead nut.

Tighten
Tighten the engine wiring harness starter lead nut to 2 N·m (18 lb in).

4. Raise the starter motor.



5. Install the starter motor bolts.

Tighten
Tighten the starter motor bolts to 50 N·m (37 lb ft).

6. Install the left side oxidation catalytic converter. Refer to Oxidation Catalytic Converter Replacement in Engine Exhaust.
7. Lower the vehicle.

Starter Replacement 3.8L V6

Important: This vehicle was designed for starter mounting without shims. However, if single or double shims have been added to correct a noise or engagement condition, reinstall the shims in their original location to ensure proper pinion-to-flywheel engagement.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the starter shield. Refer to Starter Shield Replacement .



3. Remove the starter motor bolt.
4. Remove the starter motor stud.
5. Lower the starter motor.



6. Remove the positive cable to starter nut (1).
7. Remove the positive cable.



8. Remove the starter motor lead nut from the starter.
9. Remove the starter motor lead.
10. Remove the starter motor.

1. Install the starter motor.



2. Install the starter motor lead to the starter.
3. Install the starter motor lead nut.

Tighten
Tighten the starter motor lead nut to 2 N·m (17 lb in).




4. Install the positive cable.
5. Install the positive cable to starter nut (1).

Tighten
Tighten the positive cable to starter nut (1) to 10 N·m (89 lb in).

6. Raise the starter motor.



7. Install the starter motor bolt.

Tighten
The bolt to 47 N·m (35 lb ft).

8. Install the starter motor stud.

Tighten
The starter motor stud to 45 N·m (33 lb ft).

9. Install the starter shield. Refer to Starter Shield Replacement .