Rear Axle Tie Rod Replacement for Chevrolet Camaro 1998

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Support the rear axle (2).
3. Remove the bolt or screw (6) and the nut (8).
4. Remove the bolts and screws (7 and 10) and the nuts (9).
5. Remove the tie rod (5).
6. Remove the brace (4).

1. Position the brace (4) to the right-hand underbody brace bracket.
2. Hand tighten the bolt or screw (10) and the nut (9).
3. Position the tie rod (5) to the right-hand underbody brace bracket.
4. Hand tighten the other bolt or screw (10) and the other nut (9).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the bolts and screws (7 and 10) and the nuts (9).

Tighten

•	Tighten the bolts and screws (7) to 47 N·m (35 lb ft).

•	Tighten the nuts (9) to 82 N·m (61 lb ft).

6. Install the bolt or screw (6) and the nut (8).

Tighten
Tighten the nut (8) to 82 N·m (61 lb ft).

7. Install the rear axle support.
8. Lower the vehicle.