Important:  Do not perform this check if no driveability concern exists. A driveability condition includes all PCM controlled systems and components.

The Powertrain OBD System Check is an organized approach to identifying a condition created by an electronic engine control system malfunction. The Powertrain OBD System Check is the starting point for any driveability complaint diagnosis. The Powertrain OBD System Check directs the service technician to the next logical step in diagnosing a complaint. Understanding and using the table correctly will reduce the diagnostic time and prevent the replacement of good parts.

Important: For automatic transmission DTCs, refer to Diagnostic Trouble Code Identification in Automatic Transmission 4L60-E. The DTCs associated with the automatic transmission are:

Important: For Domestic and Export DTC Types, refer to Diagnostic Trouble Code (DTC) List .

Important: This vehicle is equipped with a Powertrain Control Module (PCM) utilizing an Electrically Erasable Programmable Read Only Memory (EEPROM). Program the new PCM when diagnostics call for replacement of the PCM.

Important: If an intermittent condition exists, inspect the PCM wiring harnesses for improper installation of electrical components. Inspect for aftermarket theft deterrent devices, lights, and cellular phones. Ensure that no aftermarket equipment is connected to the Class 2 circuit. A cellular phone signal communication may cause an intermittent condition.

If multiple DTCs are set, inspect the IGN mini relay for proper operation. This relay protects the battery from a parasitic draw. The following components are powered by the IGN mini relay:

The numbers below refer to the step numbers on the diagnostic table.

1. Use a properly functioning scan tool with the diagnostic tables in this section. DO NOT use the Clear Info function unless instructed by a diagnostic procedure.

3. An Ignition 1 voltage that is too low may cause the following conditions:

•	A no start

•

Stalling

•

High idle

•	An inoperative scan tool

5. This step determines if a DTC is set for the Vehicle Theft Deterrent (VTD) system. A VTD DTC set causes the engine from starting.

6. If multiple DTCs are stored, diagnose in the following order of priority:

1.	PCM failure DTCs (P0601, P0602, P0604)

2.	System Voltage DTCs

3.	Component level DTCs (Sensors, Solenoids, Relays etc.). Multiple DTCs within this category should be diagnosed in numerical order starting with the lowest numbered DTC.

4.	System level DTCs (Misfire, Fuel Trim, etc.)

For Automatic Transmission DTCs, refer to Diagnostic Trouble Code Identification in Automatic Transmission-4L60E.

It is beneficial to review the Freeze Frame Data and/or Fail Records. Use the odometer information and the fail counter in order to determine how frequently and how recently the DTC set. This information and the other operating conditions when the DTC set may help diagnose an intermittent condition. Capturing the stored info preserves data that the PCM will lose when instructed to Clear Info at the end of a diagnostic table, or if you disconnect the PCM or replace the PCM during a diagnostic procedure. The scan tool stores the data in the scan tool's memory. Review the captured info at the end of the diagnostic procedure in order to catch the next DTC in the event there are multiple DTCs stored. Follow the order of priority as listed above.

7. Compare actual control system data with the values in the Engine Scan Tool Data List to determine if any parameter is not within limits. Keep in mind that a base engine condition (i.e. advanced cam timing) may substantially alter sensor values. If the actual data does not correspond with the values in the Engine Scan Tool Data List, refer to the appropriate system/component diagnostic aids or test descriptions.