GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Camaro 🢒 Engine 🢒 Engine Mechanical - 3.8L 🢒 Engine Oil Level Sensor and/or Switch Replacement

Removal Procedure

    Object Number: 190564 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the engine oil drain plug in order to drain the engine oil.

    3. Object Number: 440880 Size: SH
  3. Disconnect the oil level sensor electrical connector (1).

    4. Object Number: 441263 Size: SH
  4. Remove the oil level sensor from the oil pan.

Installation Procedure

    Object Number: 441263 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the oil level sensor from the oil pan.

    2. Tighten
    Tighten the oil level sensor to 20 N·m (15 lb ft).


    Object Number: 440880 Size: SH
  2. Connect the oil level sensor electrical connector (1).

    3. Object Number: 190564 Size: SH
  3. Install the engine oil drain plug.

    4. Tighten
    Tighten the engine oil drain plug to 30 N·m (22 lb ft).

  4. Refill the engine with oil.
  5. Lower the vehicle.