GM Service Manual Online
For 1990-2009 cars only

Front Wheel Speed Sensor Wiring Harness Replacement Right

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

  2. Object Number: 213395  Size: SH
  3. Disconnect the wheel speed sensor electrical connector.
  4. Remove the jumper harness (1) from the retaining clip.
  5. Remove the grommet retainer at the inner fender.
  6. Remove the harness cover from the right strut tower.
  7. Disconnect the upper jumper harness connector.
  8. Pull the grommet through the inner fender pass-through and remove the jumper harness.

Installation Procedure


    Object Number: 213395  Size: SH
  1. Route the new jumper harness through inner fender pass-through.
  2. Connect the upper jumper harness electrical connector.
  3. Install the harness cover on the right strut tower.
  4. Install the grommet retainer at the inner fender.
  5. Install the jumper harness (1) to the retaining clip.
  6. Connect the wheel speed sensor electrical connector.
  7. Lower the vehicle.

Front Wheel Speed Sensor Wiring Harness Replacement Left

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

  2. Object Number: 213395  Size: SH
  3. Disconnect the wheel speed sensor electrical connector.
  4. Remove the jumper harness (1) from the retaining clip.
  5. Remove the grommet retainer at the inner fender.
  6. Remove the transmission cable retainer and various harnesses from retainers at the left strut tower in order to access the jumper harness electrical connector.
  7. Disconnect the upper jumper harness electrical connector.
  8. Pull the grommet through the inner fender pass-through and remove the jumper harness.

Installation Procedure


    Object Number: 213395  Size: SH
  1. Route the new jumper harness through the inner fender pass-through.
  2. Connect the upper jumper harness electrical connector.
  3. Install the transmission cable retainer and various harnesses to the retainers that may have been disconnected in order to access the jumper harness.
  4. Install the grommet retainer at the inner fender.
  5. Install the jumper harness (1) to the retaining clip.
  6. Connect the wheel speed sensor electrical connector.
  7. Lower the vehicle.