GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Camaro 🢒 Steering 🢒 Steering Wheel and Column 🢒 Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle

    Object Number: 343961 Size: SH
  1. Thread the turn signal and multifunction switch assembly connector through the lock housing cover and sleeve assembly, if the switch is hanging.

    2. Object Number: 354114 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the turn signal and multifunction switch assembly and secure using 3 pan head 6 lobed socket screws (1).

    3. Tighten
    Tighten the screws to 3.5 N·m (31 lb in).

  3. Lubricate the signal switch arm assembly (3) with lithium grease.
  4. Install the signal switch arm assembly (3) onto the turn signal and multifunction switch assembly.
  5. Secure the signal switch arm assembly (3) using the round washer head screw (2).

    6. Tighten
    Tighten the screw to 2.5 N·m (22 lb in).


    Object Number: 343824 Size: SH
  6. Install the terminal connector to the turn signal and multifunction switch assembly connector.

    7. Object Number: 354116 Size: SH

    Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.

    Important: Pull carefully on all the wires to remove any wire kinks that may be inside the steering column assembly.

  7. Pull the turn signal and multifunction switch assembly connector towards the base of the column.
  8. Insert the wiring protector into the steering column bracket.
  9. Insert the steering column wire harness into the steering column wire harness strap.
  10. Install the turn signal cancel cam and upper bearing inner race. Refer to Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle .
  11. Install the tilt lever. Refer to Tilt Lever Replacement - On Vehicle .
  12. Install the multifunction lever. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .
  13. Install the hazard knob. Refer to Hazard Warning Switch Replacement .