- Remove the key from the
ignition switch.
- Connect the inflatable restraint IP module connector located behind
the IP compartment door.
- Install the connector
position assurance (CPA) to the IP module connector located behind the
IP compartment door.
- Install the right instrument panel insulator. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
in
Instrument Panel, Gages, and Console.
- Connect the inflatable
restraint steering wheel module coil connector located at the base of the
steering column.
- Install the CPA to the
steering wheel module coil connector located at the base of the steering
column.
- Install the left instrument panel insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in
Instrument Panel, Gages, and Console.
- Install the AIR BAG fuse
in the IP fuse block.
- Install the IP fuse block access door.
- Staying well away from both air bags, turn the ignition switch
to the RUN position.
10.1. | The AIR BAG indicator will flash 7 times. |
10.2. | The AIR BAG indicator will then turn OFF. |
- Perform
Diagnostic System Check - SIR
if the AIR BAG indicator does not operate as described.