TAIL LAMP MOLDING LOOSE (REPLACE MOLDING ASSEMBLY)

Subject: TAIL LAMP MOLDING LOOSE

Model and Year: 1991-92 CAPRICE

Condition: Tail lamp molding loose.

Cause: Light corrosion of the retaining clips allows the molding to come loose.

Correction: Install new molding assembly, P/N 16520255. See attached illustration.

1. Pry molding assembly rearward at the outboard end and remove.

2. Install new molding assembly.

Part Availability:

Parts are expected to be available on April 27, 1992. In case of limited inventory, parts will be placed on 400 control to waive VIP surcharges. Only verifiable emergency VIP orders will be accepted. SPO will make every effort to obtain parts. However, the part will be shipped premium transportation at dealer's expense and all other order types will be placed on backorder until the 400 control is removed.

Warranty Information:

Labor Operation: B8673

Use applicable labor time guide for labor hours.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.