TAIL LAMP MOLDING LOOSE (REPLACE MOLDING ASSEMBLY)

SUBJECT: TAIL LAMP MOLDING LOOSE (REPLACE MOLDING ASSEMBLY)

VEHICLES AFFECTED: 1991-1992 "B" CAR CHEVROLET CAPRICE (EXCEPT WAGON)

Condition: Tail lamp molding loose.

Cause: Light corrosion of the retaining clips allows the molding to come loose.

Correction: Install new molding assembly, P/N 16520255. See attached illustration.

1. Pry molding assembly rearward at the outboard end and remove.

2. Install new molding assembly.

For vehicles repaired under warranty use:

Labor Time: 0.2 Hr. (Total for Both)

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.