Removal Procedure
- Disconnect the battery ground cable. Refer to
Battery Negative Cable Disconnection and Connection.
- Remove the engine cover. Refer to
Engine Cover Replacement.
- Remove the spark plug leads (1).
- Remove the CPA lock (2) from the ignition coil
main connector (3).
- Disconnect the ignition coil main connector (3).
- Remove the ignition coil assembly to valve rocker arm cover retaining
studs (4).
- Remove the ignition coil assembly (1).
- Remove the valve rocker arm cover retaining bolts (2)
and valve rocker arm cover (1).
- Remove the valve rocker arm cover (1). Refer to
Valve Rocker Arm Cover Installation - Right Side.
Important: The valve rocker arm cover gasket is a single
use only component and must be replaced whenever the valve rocker arm cover is removed
from the cylinder head.
- Remove the valve rocker arm cover gasket (1).
Discard the
valve rocker arm cover gasket (1).
- Remove the oil fill cap (1) from the oil fill
tube (2).
Important: Do not remove the oil fill tube from the
cover, unless service is required. If the oil fill tube has been removed from the
cover, install a NEW tube during assembly.
- Remove the oil fill tube (2), from the right hand valve rocker arm cover (3)
if required.
Discard the oil fill tube (2).
Installation Procedure
- Install the NEW oil fill tube (2), to the right
hand valve rocker arm cover (3) if required.
- Install the oil fill cap (1) to the oil fill tube (2).
Important:
⢠| All gasket surfaces should be free of oil and other foreign material during
assembly. |
⢠| DO NOT reuse the valve rocker arm cover gasket. |
⢠| The valve rocker arm cover bolt grommets may be reused. |
- Install a NEW valve rocker arm cover gasket (1).
- Install the valve rocker arm cover. Refer to
Valve Rocker Arm Cover Installation - Right Side.
- Install the ignition coil assembly (1).
- Install the ignition coil bracket to valve rocker arm cover retaining
studs (4).
Tighten
Tighten the studs to 12 NĀ·m (106 lb in).
- Connect the ignition coil main connector (3).
- Install the CPA lock (2) from the ignition coil main connector (3).
- Install the spark plug leads (1).