GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Caprice WM 🢒 Body Systems 🢒 Vehicle Access 🢒 Door Lock Cylinder Replacement

Removal Procedure

    Important: Do not attempt repairs in order to correct lock cylinder discrepancies. Replace the lock cylinder.

  1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement.
  2. Pull the rear half of the water deflector away from the drivers door panel in order to access the door lock cylinder.

    3. Object Number: 1939909 Size: SH
  3. Remove the lock actuating rod (1) from the lock cylinder (2).

    4. Object Number: 1939908 Size: SH

    Important: Remove the rubber blanking grommet to expose lock cylinder retaining bolt (1).

  4. Remove the lock cylinder to outside door handle retaining bolt (1).

    5. Object Number: 1939864 Size: SH
  5. Remove the lock cylinder (2) from the outside door handle (1).

Installation Procedure

    Object Number: 1939864 Size: SH
  1. Position the lock cylinder (2) to the outside door handle (1).

    2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1939908 Size: SH
  2. Install the lock cylinder to outside door handle retaining bolt (1).

    3. Tighten
    Tighten the bolt to 4 N-m (35 lb in).

  3. Install the rubber blanking grommet to the door.

    4. Object Number: 1939909 Size: SH

    Important: The lock actuating rod (2) pushes into the lock cylinder retaining clip (1).

  4. Install the lock actuating rod (1) to the lock cylinder retaining clip (2) (if fitted).

    5. Important: Firmly press the water deflector where adhesive is applied to make sure water tight bond.

  5. Install the rear half of the water deflector to the door panel.
  6. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement.