• | EL-47826 TPMS Activation and Test Tool. |
• | EL-49310 TPMS Activation and Test Tool. |
If the RFA is replaced, the following procedures must be performed:
Important: When the RFA is programmed via the service programming system (SPS) the remote key and TPMS pressure sensor data will be erased. Remote keys and TPMS pressure sensors (where installed) must be programmed whenever a RFA is replaced.
Important: Performing the Erase All and Program Remotes procedure is prohibited without TIS approval. Refer to Obtaining TIS Approval for more information.
Important: Remote keys must be programmed to the RFA. Remote keys can be reused, a maximum of 4 remote keys may be reprogrammed.
Important: The scan tool must stay connected until all of the remote keys are programmed.
Important: The following procedures are only required on vehicles where the tyre pressure monitoring system (TPMS) is installed.
Important: To program each TPMS pressure sensor ID into the RFA and/or to activate a sensor, the mandatory TPMS Activation and Test Tool EL-47826 or EL-49310 is required.
Important: For this vehicle, the TPMS Activation and Test Tool LED and audible tone do not operate during the program procedure, activation of each TPMS pressure sensor is confirmed using the scan tool.
Perform the Diagnostic Repair Verification after completing the proceeding procedures.