GM Service Manual Online
For 1990-2009 cars only

    Important:  When a suitable hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

  1. Install a suitable hood brace to the vehicle.

  2. Object Number: 2037775  Size: SH
  3. Loosen the hood hinge to dash and cowl panel brace retaining bolts (1).

  4. Object Number: 1936383  Size: SH
  5. Loosen the hood hinge to hood retaining bolts (1).
  6. Adjust the hood to obtain an even gap between 2.25 mm to 3.75 mm on both sides between the hood and the fenders, so that the hood is flush with both fenders on the front edge.
  7. Adjust the hood to obtain an even gap between 2 mm to 6 mm between the hood and the front bumper fascia so that the hood is flush with the front bumper fascia.
  8. Notice: Refer to Fastener Notice in the Preface section.

  9. Tighten the hood hinge to hood retaining bolts (1).
  10. Tighten
    Tighten the bolts to 20 N·m (15 lb ft).


    Object Number: 2037775  Size: SH
  11. Tighten the hood hinge to dash and cowl panel brace retaining bolts (1).
  12. Tighten
    Tighten the bolts to 20 N·m (15 lb ft).