Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
DTC Descriptor
DTC C1210: Right Rear Wheel Speed Sensor Circuit HighDTC C1224: Right Rear Wheel Speed Sensor Circuit
DTC C1228: Right Rear Wheel Speed Sensor Circuit Range/Performance
DTC C1235: Right Rear Wheel Speed Sensor Circuit Low
Circuit/System Description
The wheel speed sensor receives a 12-volt power supply voltage from the electronic brake control module (EBCM) and provides an output signal to the EBCM. As the wheel spins, the wheel speed sensor sends the EBCM a DC square wave signal. The EBCM uses the frequency of the square wave signal to calculate the wheel speed. If the EBCM identifies an error, it sets a code and communicates via GMLAN to the engine control module (ECM).
Conditions for Running the DTC
Ignition voltage is between 9 and 16 volts.
Conditions for Setting the DTC
| • | The engine must be ON. |
| • | The vehicle speed is greater than 16 km/h (10 mph). |
Action Taken when the DTC Sets
DTCs C1210, C1224, C1228 and C1235 are type C DTCs.
Conditions for Clearing the MIL/DTC
DTCs C1210, C1224, C1228 and C1235 are type C DTCs.
Reference Information
Schematic Reference
Connector End View Reference
Electrical Information Reference
| • | Circuit Testing . |
| • | Wiring Repairs . |
Scan Tool Reference
Circuit/System Verification
The ECM sets DTCs C1210, C1224, C1228 and C1235 in conjunction with the EBCM, any EBCM wheel speed sensor DTC should be diagnosed ahead of performing the test below.
Circuit/System Testing
- Verify that no other DTCs are set.
- Ignition ON, using a scan tool view the current DTC's.
| ⇒ | If any other DTCs are set, refer to Diagnostic Trouble Code (DTC) Type Definitions . |
| ⇒ | If any of the following DTCs C1210, C1224, C1228 or C1235, are set to current replace ECM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Engine Control Module Replacement for engine control module replacement, setup and programming.
