Rear Bumper Fascia Extension Replacement SWBLWB
Removal Procedure
Caution: Refer to Safety Glasses Caution in the Preface section.
Caution: Refer to Vehicle Lifting Caution in the Preface section.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the rear wheelhouse liner. Refer to
Rear Inner Wheelhouse Replacement.
- Remove the rear bumper fascia extension to rear bumper
fascia retaining screw (1).
- Disengage the rear bumper fascia extension retaining
clips (1) from the rear bumper fascia.
- Remove the rear bumper fascia extension (2) from the vehicle.
Installation Procedure
- Position the rear bumper fascia extension (2)
to the vehicle.
- Engage the rear bumper fascia extension retaining clips (1) to
the rear bumper fascia.
Notice: Refer to Fastener Notice in the Preface section.
- Install the rear bumper fascia extension to rear bumper fascia retaining screw (1).
Tighten
Tighten the screw to 2 N·m (18 lb in).
- Install the rear wheelhouse liner. Refer to
Rear Inner Wheelhouse Replacement.
- Lower the vehicle.
Rear Bumper Fascia Extension Replacement LWBHSV
Removal Procedure
Caution: Refer to Safety Glasses Caution in the Preface section.
Caution: Refer to Vehicle Lifting Caution in the Preface section.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the rear bumper fascia. Refer to
Rear Bumper Fascia Replacement.
- Remove the rear bumper extension to rear bumper fascia
retaining screws (1).
- Remove the rear bumper extension to rear fascia retaining
scrivets (1)
- Remove the outer rear bumper extension to rear bumper
fascia retaining screws (1)
Important: The rear bumper extension (1) must
be disengaged and removed on a horizontal plane to ensure the scrivet mounting points (2)
are not damaged.
- Disengage the rear bumper extension (1) away from the rear bumper fascia (2)
in a horizontal rearward motion, without straining any of the scrivet mounting points (3).
Installation Procedure
Important: The rear bumper extension (1) must
be disengaged and removed on a horizontal plane to ensure the scrivet mounting points (3)
and are not damaged.
- Engage the rear bumper extension (1) into the rear bumper fascia (2)
in a horizontal forward motion, without allowing any of the mounting points (3)
to become misaligned.
- Install the rear bumper extension to rear fascia retaining
scrivets (1).
Notice: Refer to Fastener Notice in the Preface section.
- Install the outer rear bumper extension to rear bumper fascia retaining screws (1).
Tighten
Tighten the screws to 2 Nm (18 lb in).
- Install the rear bumper extension to rear bumper fascia
retaining screws (1).
Tighten
Tighten the screws to 2 Nm (18 lb in).
- Install the rear bumper fascia. Refer to
Rear Bumper Fascia Replacement.
- Lower the vehicle to the ground.