GM Service Manual Online
For 1990-2009 cars only

Servicing of Audio System and Introduction of Radio Changeover for 2007 and Later Model Years

Subject:Servicing of Audio System and Introduction of Radio Changeover for 2007 and Later Model Years

Models:2007-2008 Chevrolet Caprice and Lumina (Middle East Export)



Bulletin is updated with issue 2 to correct instruction regarding version 5. facia replacement, which is not possible following release of version 6. software to TIS.

The purpose of this bulletin is to advise of the introduction of revised software in the audio system in Lumina and Caprice vehicles, effecting the method of servicing pre-breakpoint vehicles. This also announces the extension of the existing Blaupunkt changeover program to now include 2007 and later model years.

In May 2007, at the breakpoints shown later in this bulletin, changes were made to the radio software for all Lumina and Caprice models. The previous software version was designated Ver 5. The new version is Ver 6. The two software levels and audio system components are incompatible.

As a result of this software upgrade:

    • Ver5 radios cannot be reprogrammed to Ver6 and Ver6 cannot be reprogrammed to Ver5.
    • Ver5 IRC, Fascia and SIC (where applicable) cannot be mixed in the same vehicle with Ver6 IRC, fascia or SIC. (Backward compatibility of Ver6 Fascia and SIC with Ver 5 IRC to be confirmed.)
    • Limitations in TIS will enable it to support only one software level. From release of TIS CD#9 (September 2007 TIS 2 Web), TIS will support only Ver 6 software. From this revision, it will no longer be possible to program ver 5 IRC of fascia.
    • Prior to release of Ver6 software into TIS, it will not be possible to program a replacement Ver6 radio. In the event of a radio requiring replacement during this interim period, please contact TAC. Ver6 Fascia and SIC can be replaced independently of the radio.

Radio Servicing

Beginning with TIS CD#9, September 1, 2007, the software version in TIS and TIS2 Web SPS will be changed to Ver6.

    • Dealerships will be able to program Ver6 (only) radios as replacement units
    • Ver5 IRC and fascia will no longer be able to be programmed by SPS. Stock of IRCs and fascias cannot be used for warranty or retail repairs as IRCs and fascias will not be able to be programmed using a Tech 2. Hold Ver5 IRCs and fascias in service parts stock pending advice on the return process
    • Replacement of a radio IRC or fascia in pre-breakpoint vehicles previously equipped with Ver5 will require replacement of the IRC, Fascia and SIC to Ver6 specification.
    • Vehicles already equipped with Ver6 radios can have individual IRC, fascia or SIC replaced separately and programmed using TIS
    • Ver6 IRC, fascia and SIC will be available as changeover units through Central Motors, extending the changeover program (refer to service bulletin H07-08-03) from 2003-2006 model years to now include 2007 and later model years. Conditions outlined in bulletin H07-08-03 will apply to 2007 and later model years. Part numbers are shown below.

Dealer Action

From release of new Ver6 software into TIS or TIS 2 Web (approximately September 7, 2007), if a Ver5 (pre-breakpoint ) vehicle requires a replacement IRC or fascia, contact Central Motors with diagnosis information and request the necessary IRC, fascia and SIC as changeover. Changeover will require installation of upgraded Ver6 radio, fascia and (if equipped) SIC. Return all removed components to dhangeover service (Central Motors) as per the instructions shown in service bulletin H07-08-03. When equipped, program the audio system to Ver6 using updated TIS or TIS 2 Web. If a Ver6 (post- breakpoint) vehicle requires a replacement IRC, fascia or SIC, contact Central Motors and request the affected part only. Follow replacement instructions as shown in Service information (SI).

Following the release in TIS of Ver6 software (mid-September), hold service parts stock of Ver5 IRC and fascia (listed below). Instructions will be provided regarding return for credit. Ver5 SIC may continue to be used in conjunction with Ver5 IRC/ fascia if only the SIC is to be replaced.

Breakpoint Information

Ver6 radios were introduced (May 2007) at the following breakpoints:

RPO Code

VIN Breakpoint

UT3

6G1EK52BX8L946253

UWP

6G1EX55U88L946315

UWR

6G1EL54BX8L946053

UWQ

6G1MZ55H68L946364


Affected Part Number

 

Description

Early Design Ver5

2nd Design Ver5

1st Design Ver6

2nd Design Ver6

Fascia

LS Caprice/ Lumina

92 196 192

92 200 346

92204832

 

LS with 6 stack

92 196 193

92 200 347

92204834

 

S and SS with Single CD

92 196 194

92 200 348

92204835

 

S and SS with 6 Stack

92 196 195

92 200 349

92204836

 

Lumina LTZ

92 199 176

92 200 350

92204837

 

Caprice LTZ/ SS

92 199 190

92 200 356

92204842

 

Caprice Royale (ME)

92 199 181

92 200 355

92204844

 

SIC

L1 SIC (GREEN)

92 199 182

92 200 357

92204820

 

SPORT SIC (RED)

92 199 183

92 200 358

92204816

 

IRC

L1 IRC

92 199 168

92 200 341

92204792

 

L2 IRC

92 199 169

92 200 342

92204796

 

L3-4 IRC

92 199 170

92 200 343

92204800

92212866

L5 IRC

92 199 171

92 200 344

92204803

92213089