• | J 42385-100 Thread Repair Kit |
• | J 45059 Angle Meter |
Important: Make sure the locating sleeves (2) are correctly installed to the maximum height (A) of 8.3 mm (0.33 in).
Important: The cylinder head gasket (3) will fit on either side of the engine. Make sure the tab on the cylinder head gasket (1) is located towards the front half point and the stamping FRONT on the cylinder head gasket (2) is facing the front of the engine.
Important: Do not use any type of sealant on the cylinder head gasket (1), unless specified.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
• | First Pass: Tighten the M11 cylinder head bolts (1-10) in sequence to 30 N·m (22 lb ft). |
• | Second Pass: Tighten the M11 cylinder head bolts (1-10) in sequence to 90 degrees using the J 45059 . |
• | Final Pass: Tighten the M11 cylinder head bolts (1-10) in sequence to 70 degrees using the J 45059 . |
• | Tighten the M8 cylinder head bolts (11-15) to 30 N·m (22 lb ft). Begin with the centre bolt (11) and alternating side-to-side, work outward tightening all of the bolts. |
• | J 42385-100 Thread Repair Kit |
• | J 45059 Angle Meter |
Caution: Refer to Safety Glasses Caution in the Preface section.
Notice: Clean all dirt, debris, and coolant from the engine block cylinder head bolt holes. Failure to remove all foreign material may result in damaged threads, improperly tightened fasteners or damage to components.
Important:
• Do not use the cylinder head bolts again. Install NEW cylinder head bolts
during assembly. • Do not use any type of sealant on the cylinder head gasket, unless specified. • The cylinder head gaskets must be installed in the proper direction and
position.
Thread repair tool J 42385-107 may be used to clean the threads of old threadlocking material.
Notice: Refer to Fastener Notice in the Preface section.
Tighten