If the carpet or the pad or insulator is wet, use the following criteria for
drying or for replacing the components:
| • | For a 1-piece carpet assembly bonded to a cotton or a fiber padding,
replace the entire assembly. |
| • | For a 2-piece carpet assembly with a cotton or a fiber padding, replace
the padding only. While the carpet is out of the vehicle, dry the carpet using the
method described below. |
| • | For a 1-piece carpet assembly bonded to a foam padding or attached to
a synthetic padding, dry the carpet using the method described below. |
| • | For a 2-piece carpet assembly with a synthetic padding, dry the assembly
using the method described below. |
Drying Method
- If you observe puddles of liquid on the carpet face, use a wet vacuum
to remove the excess moisture.
- Blot the face of the carpet with a towel in order to absorb as much moisture
as possible.
- Point a fan at the affected area and air dry the carpet.
