Removal Procedure
- Cycle the sunroof window to the vent position in order to ease in the
removal of the sunshade panel.
- Remove the headliner. Refer to
Headlining Trim Panel Replacement.
- Remove the sunroof module. Refer to
Sunroof Module Assembly Replacement.
- Remove the sunshade stop rubber to sunroof module
retaining screw (2). Repeat for the opposite side.
- Remove the sunshade stop rubber (1) from the sunroof module by
sliding the sunshade stop rubber to the rear of the sunroof module. Repeat for the
opposite side.
- Remove the end caps (1) from the sunroof rail.
- Carefully remove the sunshade panel (2) by sliding the sunshade
panel towards the rear of the sunroof.
Important: Do not apply excessive pressure when arching
the sunshade panel, failure to comply may result in damage to the sunshade panel.
- Remove the sunshade panel (1) from the sunroof module (3).
Installation Procedure
- Position front edge of the sunshade panel (2)
to the track.
Important: Do not apply excessive pressure to the sunshade
panel, failure to comply may result in damage to the sunshade panel.
- Carefully install the sunshade panel (2) by sliding the sunshade panel
toward to the front of the sunroof module (3).
Notice: Refer to Fastener Notice in the Preface section.
- Install the sunroof end caps (1) to the sunroof rail.
Tighten
Tighten the screw to 1 N·m (9 lb in).
- Slide the sunshade panel forward and rearward to make sure free operation
is present.
- Install the sunshade stop rubber (1) to the
sunroof module. Repeat for the opposite side.
- Install the sunshade stop rubber to sunroof module retaining screw (2).
Repeat for the opposite side.
Tighten
Tighten the screws to 1 N·m (9 lb in).
- Install the sunroof module. Refer to
Sunroof Module Assembly Replacement.
- Install the headliner. Refer to
Headlining Trim Panel Replacement.