Removal Procedure
Important: When a suitable hold open device is being
removed or installed, provide alternate support to avoid the possibility of damage
to the vehicle or personal injury.
- Install a suitable liftgate brace to the vehicle.
- Remove the rear end trim finish panel. Refer to
Rear End Trim Finish Panel Replacement.
- Remove the luggage shade. Refer to
Luggage Shade Replacement.
- Remove the rear compartment floor panel carpet. Refer to
Rear Compartment Floor Panel Carpet Replacement.
- Remove the load floor stationary panel carpet. Refer to
Load Floor Stationary Panel Carpet Replacement.
- Remove the load floor front panel carpet. Refer to
Load Floor Front Panel Carpet Replacement.
- Remove the rear compartment
floor panel carpet exterior support foams (2).
- Remove the rear compartment floor panel centre support foam (1).
- Fold the rear seat forward.
- Remove the quarter upper trim panel to body
retaining screws (1).
- Remove the rear compartment convenience hooks (2).
- Carefully disengage the quarter trim panel
to body retaining clips (1).
Important: Step 13 is valid for the removal of the right-hand
side quarter trim panel only.
- Disconnect the right side quarter trim panel wiring harness (1) from
the rear body wiring harness (2).
- Remove the quarter panel trim (3) from the vehicle.
Installation Procedure
- Position the quarter trim panel to the vehicle.
Important: Step 2 is valid for the installation of the
right-hand side quarter trim panel only.
- Connect the right side quarter trim panel wiring harness (1) to the rear
body wiring harness (2).
- Carefully engage the quarter trim panel
to body retaining clips (1).
- Install the rear compartment convenience
hooks (2).
Notice: Refer to Fastener Notice in the Preface section.
- Install the quarter upper trim panel to body retaining screws (1).
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Position the rear seat to the original upright locked position.
- Install the rear compartment floor panel
centre support foam (1).
- Install the rear compartment floor panel carpet exterior support foams (2).
- Install the load floor front panel carpet. Refer to
Load Floor Front Panel Carpet Replacement.
- Install the load floor stationary panel carpet. Refer to
Load Floor Stationary Panel Carpet Replacement.
- Install the rear compartment floor panel carpet. Refer to
Rear Compartment Floor Panel Carpet Replacement.
- Install the luggage shade. Refer to
Luggage Shade Replacement.
- Install the rear end trim finish panel. Refer to
Rear End Trim Finish Panel Replacement.
Important: When a suitable hold open device is being
removed or installed, provide alternate support to avoid the possibility of damage
to the vehicle or personal injury.
- Remove the suitable liftgate brace from the vehicle.