The engine control module (ECM) supplies a voltage near 450 mV between the heated oxygen sensor (HO2S) high signal circuit and the low reference circuit. The HO2S varies the voltage over a range from about 1,000 mV when the exhaust is rich, down through about 10 mV when the exhaust is lean. The ECM monitors and stores the HO2S voltage information. The ECM evaluates the HO2S voltage samples in order to determine the amount of time that the HO2S voltage was out of range. The ECM compares the stored HO2S voltage samples taken within each sample period and determines if the majority of the samples are out of the operating range.

The ECM detects that the rear HO2S voltage is greater than a predetermined amount.

DTC P2271 is a Type B DTC.

DTC P2271 is a Type B DTC.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

1. Ignition ON, observe the scan tool DTC information parameter. Verify DTCs P0137, P0138, or P0140 are not set.

⇒	If any of the listed DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.

2. Operate the engine above 1,200 RPM for 30 seconds, observe the scan tool HO2S voltage parameter. The reading should fluctuate above and below the range of 350-550 mV.
3. If the vehicle passes the Circuit/System Verification test, then operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records Data List.

1. Engine idling, move the HO2S harness for the rear sensor between the HO2S harness connector and the engine control module (ECM) while monitoring the appropriate scan tool HO2S voltage parameter. Verify the reading does not change abruptly while moving the related harnesses.

⇒	If the reading changes abruptly, repair the circuit as necessary.

2. Ignition OFF, disconnect the harness connector at the appropriate HO2S.
3. Ignition ON, verify the scan tool HO2S parameter is between 350-500 mV.

⇒	If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.

4. Verify none of the following conditions exist:

•	Rich fuel injectors--Refer to Fuel Injector Balance Test with Special Tool or Fuel Injector Balance Test with Tech 2 .

•	Water intrusion in the HO2S harness connector

•	High fuel system pressure--Refer to Fuel System Diagnosis .

•	Fuel that is contaminated--Refer to Alcohol/Contaminants-in-Fuel Diagnosis .

•	A collapsed air intake duct

•	A restricted air filter element

•	Exhaust system restrictions

•	Excessive fuel in the crankcase

•	An engine mechanical condition--Refer to Symptoms - Engine Mechanical .

⇒	If you find any of the above conditions, repair as necessary.

5. If all circuits/connections test normal, replace the applicable HO2S.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.