Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B1517 03 : Battery Voltage Below ThresholdDTC B1517 07 : Battery Voltage Above Threshold
DTC B1517 5A : Battery Voltage Plausibility Failure
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Battery Positive Voltage Circuit | B1517 03 | B1517 03 | -- | B1517 5A B1517 07 |
Ground Circuit | B1517 03 | B1517 03 | -- | B1517 5A B1517 07 |
Circuit/System Description
The body control module (BCM) has designated circuits for monitoring vehicle system voltage. The BCM monitors the system voltage to ensure that the voltage stays within the proper range. Damage to components, and incorrect data may occur when the voltage is out of range. The BCM monitors the system voltage over an extended length of time. If the BCM detects the system voltage is outside an expected range for the calibrated length of time, or the BCM battery sense circuits differ by 2 volts, DTC B1517 will set. Other modules also monitor system voltage the system voltage message is sent to the other modules and will default to 12.9 volts.
Conditions for Running the DTC
The DTC shall run only if the BCM has power, ground, and the ignition is not in the START mode. This DTC shall execute regardless of battery voltage.
Conditions for Setting the DTC
B1517 03
The battery voltage falls below 11 volts, engine speed less than 1,100 RPM for 15 seconds.
B1517 07
The battery voltage rises above 16 volts, engine speed less than 1,100 RPM for 15 seconds.
B1517 5A
The battery voltage differs by 2 volts on the BCM battery sense circuits for 10 seconds.
Action Taken When the DTC Sets
The charge indicator on the instrument panel cluster (IPC) illuminates.
Conditions for Clearing the DTC
| • | The DTC will clear current status when fault is no longer present. |
| • | The history DTC will clear after 50 consecutive ignition cycles have occurred without a malfunction. |
Diagnostic Aids
With any module voltage performance DTC, always perform the Charging System Test to ensure the charging system is functioning properly.
Reference Information
Schematic Reference
Starting and Charging Schematics
Connector End View Reference
Engine Electrical Connector End Views
Electrical Information Reference
Circuit/System Testing
- If the DTC is history refer to Charging System Test .
- If the DTC is current, turn ON the ignition, test for 10.5-15 volts between the battery positive voltage circuit of the BCM and the ground circuit of the BCM.
- Replace the BCM.
| ⇒ | If the voltage is not within 10.5-15 volts. Test the battery positive and ground circuits of the BCM for high resistance or an open, and repair as necessary. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BCM replacement, setup, and programming
