For 1990-2009 cars only
Removal procedure
- Disconnect the negative battery cable.
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement.
- Remove the engine mount support bracket. Refer to Engine Mount Replacement - Right Side.
- Disconnect the electrical connector (1) from the camshaft position actuator solenoid (2).
- Remove the bolt (1) attaching the camshaft position actuator solemoid(2).
- Remove the camshaft position actuator solenoid by twisting the actuator to release it, then pulling it away from the front of the engine cover.
Notice: Refer to Battery Disconnect Caution in the Preface section.
Important: The replacement procedure for the intake (1) and exhaust (2) camshaft position actuator solenoids are typicall the same. The following procedure is specific to the intake camshaft position actuator solenoid, the exhaust is similar.
Important: Clean the area around the camshaft position actuator solenoid to prevent debris from entering the engine.
Important: When removing the camshaft position actuator solenoid, use care to prevent damage to the solenoid seal.
Installation procedure
- Inspect the camshaft position actuator seal (1) for damage and replace as necessary.
- Lubricate the lip of the camshaft position actuator solenoid seal with clean engine oil.
- Install the camshaft position actuator solenoid.
- Connect the electrical connector.
- Install the engine mount support bracket. Refer to Engine Mount Replacement - Right Side.
- Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement.
- Connect the negative battery cable.
Tighten
Tighten the camshaft position actuator solemoid attaching bolt to 10 N·m (89 lb in)
