Special Tools

DW-110-060 Engine Assembly Support Fixture

Important: Only lift the engine far enough to take the weight off the transaxle front mount assembly, or damage to the mount and lifting equipment failure may occur.

1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
2. Support the engine assembly using DW-110-060 .



3. Remove the transaxle front mount-to-cradle through bolt.
4. Remove the transaxle front mount retaining bolts from the transaxle.
5. Remove the transaxle front mount assembly.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the transaxle front mount assembly.

Tighten
Tighten the transaxle front mount retaining bolts to 50 N·m (37 lb ft).

Important: Before tightening the transaxle front mount through bolt swing the engine assembly backwards and forwards or from the side to side for the proper alignment.

2. Install the transaxle front mount through bolt.

Tighten
Tighten the transaxle front mount-to-cradle through bolt to 90 N·m (66 lb ft).

3. Remove DW-110-060 .
4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.