GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Captiva 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Crankshaft Position Sensor Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 1804738 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Remove the exhaust front pipe. Refer to Front Pipe Replacement.
  3. Remove the transfer case. Refer to Transfer Case Assembly Replacement.
  4. Disconnect the wiring harness connector (1) from the crankshaft position (CKP) sensor (2).

    5. Object Number: 1804741 Size: SH

    Note: Clean the area around the CKP sensor before removal to avoid debris from entering the engine.

  5. Remove the CKP sensor attaching bolt (1).
  6. Remove the CKP sensor (2), by first twisting the sensor to release it, and then pulling it away from the engine block to remove it.

Installation Procedure


    Object Number: 1804741 Size: SH
  1. Lubricate the CKP sensor O-ring with clean engine oil.
  2. Reinstall the CKP sensor (2) by pushing down on the sensor to engage the sensor O-ring in the engine block.

    3. Caution: Refer to Fastener Caution in the Preface section.

    Note: Ensure the CKP sensor is fully seated before tightening the attaching bolt to the specified torque.

  3. Install the CKP sensor attaching bolt (1) and tighten to 10 N·m (89 lb in).
  4. Connect the CKP sensor connector.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.