For 1990-2009 cars only
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the fluid level check plug.
- Verify that the fluid is level with the opening.
- If the transaxle is not properly filled, carefully add SAE75W90 fluid until it begins to flow out of the fill/check plug.
- Install the fluid level check plug and tighten to 6 N·m (53 lb in) plus an additional 45-180 degrees.
- Lower the vehicle.
Note: It is not necessary to check the fluid level unless the fluid has been changed or a leak is suspected. Inspect the fluid level only when the engine is off. Ensure the vehicle is level.
Caution: Refer to Fastener Caution in the Preface section.
