Intermediate Shaft Replacement LE5

Special Tools

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the right front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement .



3. Remove and discard the wheel drive shaft retaining ring.
4. Remove the O-ring seal from the from the intermediate drive shaft.



5. Remove the intermediate drive shaft mounting bolts.



6. Using the J 2619-01 and the J 44467 , remove the intermediate shaft from the transmission.
7. Remove the J 2619-01 and the J 44467 from the intermediate shaft.



8. Remove the intermediate drive shaft from the mounting bracket.



9. Remove the intermediate drive shaft bracket mounting bolts and bracket, if needed.

1. Position the intermediate drive shaft mounting bracket on the engine block.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the intermediate drive shaft mounting bracket bolts.

Tighten
Tighten the mounting bolts to 22 N·m (16 lb ft).




3. Install the J 44394 on the intermediate drive shaft.



4. Install the intermediate drive shaft.
5. Remove the J 44394 from the intermediate drive shaft.



6. Install the mounting bolts for the intermediate drive shaft.
7. Install the intermediate drive shaft mounting bolts

Tighten
Tighten the mounting bolts to 30 N·m (22 lb ft).

8. Install a new O-ring for the intermediate drive shaft.
9. Install a new retaining ring for the intermediate drive shaft .
10. Install the right wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement .
11. Remove the support and lower the vehicle.

Intermediate Shaft Replacement LY7

Special Tools

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the wheel drive shaft assembly. Refer to Front Wheel Drive Shaft Replacement .




Important: Remove the retaining ring. DO NOT re-use the retaining ring discard. Use NEW only.

3. Remove the retaining clip for the wheel drive shaft.



4. Remove the mounting bolts for the intermediate shaft support bracket.
5. Support the wheel drive shaft.



6. Assemble the J 44467 and the J 2619-01 .
7. Install the J 44467 and the J 2619-01 in the retaining ring groove on the wheel drive shaft.
8. Using the J 44467 and the J 2619-01 , remove the wheel drive shaft from the transmission.



9. Remove the wheel drive shaft from the vehicle.

1. Install the intermediate shaft in the transmission.
2. Move the intermediate shaft back and forth to ensure that the intermediate shaft is properly seated.



3. Hand tighten the mounting bolts for the intermediate shaft mounting bracket.

Notice: Refer to Fastener Notice in the Preface section.

4. Tighten the mounting bolts for the intermediate shaft.

Tighten
Tighten the mounting bolts to 22 N·m (16 lb ft).




5. Install the NEW intermediate shaft retaining.
6. Install the wheel drive shaft assembly. Refer to Front Wheel Drive Shaft Replacement .
7. Remove the support and lower the vehicle.