1

Video Display Assembly Screws (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2.5 N·m ( 22 lb in)

Procedure

Make sure that all 4 washers on the 4 mounting screws are accounted for. If any washers are off the screw and loose, discard to prevent a rattle. The washers were required only for assembly plant installation, and can be used if still on the screw or they can be discarded.

2

Video Display Assembly

Procedure

1. Pull down to disengage the retainer clip and remove from the vehicle.
2. Disconnect the electrical connector.