Preliminary Procedure

1. Remove the rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement .
2. Remove the inner rear wheel opening molding nut.
3. Release the retainers from the wheelhouse.
4. Release the rear wheel opening molding from the rear edge of the lower rocker panel molding.
5. Remove the rear wheel opening molding from the vehicle.

1

Rear Wheel Opening Nut

Notice: Refer to Fastener Notice in the Preface section.

Tighten
4.0 N·m(35 lb in)

2

Rear Wheel Opening Molding Retainers (Qty: 8)

Tip
Replace any broken retainers upon re-assembly.

3

Rear Wheel Opening Molding