For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provide an overview of each diagnostic category. |
DTC Descriptor
DTC C056D 39: ECU Hardware Performance Internal Electronic FailureCircuit/System Description
The power steering control module (PSCM) continuously monitors the internal circuitry within the module.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
This DTC will set if the PSCM detects an internal malfunction within the module.
Actions Taken When DTC Sets
| • | DTC C056D is stored in memory. |
| • | The driver information center (DIC) displays the SERVICE POWER STEERING warning message. |
| • | No steering assist. |
Conditions for Clearing the DTC
| • | A current DTC will clear on the next malfunction free ignition cycle. |
| • | A history DTC will clear after 100 consecutive malfunction-free ignition cycles, without the repeat of the internal malfunction. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Power Steering System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Verify DTC C056D 39 is not set.
| ⇒ | If the DTC is set, clear the DTC. Verify the DTC does not reset. If the DTC resets, replace the PSCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for PSCM replacement, setup, and programming
