GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Captiva Sport 🢒 Engine 🢒 Engine Controls and Fuel - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Manifold Absolute Pressure Sensor Replacement

Removal Procedure

    Object Number: 1887829 Size: SH
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  2. Disconnect the engine wiring harness electrical connector (2) from the manifold absolute pressure (MAP) sensor (1).

    3. Object Number: 1887830 Size: SH
  3. Remove the MAP sensor bolt (1) and sensor (2).

Installation Procedure

    Object Number: 1887830 Size: SH
  1. Lubricate the MAP sensor O-ring seal with clean engine oil.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the MAP sensor (2) and bolt (1).

    3. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1887829 Size: SH
  3. Connect the engine wiring harness electrical connector (2) to the MAP sensor (1).
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.

Removal Procedure

    Object Number: 1887829 Size: SH
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  2. Disconnect the engine wiring harness electrical connector (2) from the manifold absolute pressure (MAP) sensor (1).

    3. Object Number: 1887830 Size: SH
  3. Remove the MAP sensor bolt (1) and sensor (2).

Installation Procedure

    Object Number: 1887830 Size: SH
  1. Lubricate the MAP sensor O-ring seal with clean engine oil.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the MAP sensor (2) and bolt (1). Tighten the bolt to 10 N·m (89 lb in).

    3. Object Number: 1887829 Size: SH
  3. Connect the engine wiring harness electrical connector (2) to the MAP sensor (1).
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.