- Remove the oxygen sensor from the manifold.
- Clean the exhaust manifold in solvent.
- Dry the exhaust manifold with compressed air.
- Inspect the heat shield for damage.
- Use a straight edge and a feeler gage and measure the exhaust manifold mounting face for warpage.
Important:
• Do not reuse the exhaust manifold-to-cylinder head gaskets. Upon installation of the exhaust manifold, install a NEW gasket. An improperly installed gasket or leaking exhaust system may effect On-Board Diagnostics (OBD) II system
performance. • Remove the oxygen sensor prior to cleaning the manifold. Do not submerge the oxygen sensor in cleaning solvent.
Caution: Wear safety glasses in order to avoid eye damage.
An exhaust manifold face with warpage in excess of 0.25 mm (0.0100 in) may cause an exhaust leak and may effect OBD II system performance. Exhaust manifolds not within specifications must be replaced.
- Remove the oxygen sensor from the manifold.
- Clean the exhaust manifold in solvent.
- Dry the exhaust manifold with compressed air.
- Inspect the heat shield for damage.
- Use a straight edge and a feeler gage and measure the exhaust manifold mounting face for warpage.
Note:
• Do not reuse the exhaust manifold-to-cylinder head gaskets. Upon installation of the exhaust manifold, install a NEW gasket. An improperly installed gasket or leaking exhaust system may effect On-Board Diagnostics (OBD) II system
performance. • Remove the oxygen sensor prior to cleaning the manifold. Do not submerge the oxygen sensor in cleaning solvent.
Warning: Refer to Safety Glasses Warning in the Preface section.
An exhaust manifold face with warpage in excess of 0.25 mm (0.0100 in) may cause an exhaust leak and may effect OBD II system performance. Exhaust manifolds not within specifications must be replaced.
