- Install the engine front cover with a new gasket.
- Install the long water pump bolt.
- Install the engine front cover bolts.
- Install the drive belt tensioner bracket.
- Install the drive belt tensioner bracket bolts.
- Install the accessory drive belt tensioner.
- Install the accessory drive belt tensioner bolt.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the water pump bolt to 25 N·m (18 lb ft).
Tighten
Tighten the engine front cover bolts to 25 N·m (18 lb ft).
Tighten
Tighten the drive belt tensioner bracket bolts to 45 N·m (33 lb ft).
Tighten
Tighten the bolt to 45 N·m (33 lb ft).
- Install the engine front cover with a new gasket.
- Install the long water pump bolt and tighten to 25 N·m (18 lb ft).
- Install the engine front cover bolts and tighten to 25 N·m (18 lb ft).
- Install the drive belt tensioner bracket.
- Install the drive belt tensioner bracket bolts and tighten to 45 N·m (33 lb ft).
- Install the accessory drive belt tensioner.
- Install the accessory drive belt tensioner bolt and tighten to 45 N·m (33 lb ft).
Caution: Refer to Fastener Caution in the Preface section.
