- Install the coolant crossover pipe assembly onto the engine.
- Install the engine lift bracket (1) and the front coolant crossover pipe bolts (3).
- Install the side coolant crossover pipe bolt (2).
- Install the idler pulleys and bolts.
- Install the coolant vent pipe and bolt (2).
- Install the heater inlet/outlet pipe and bolt (1).
- Install the thermal bypass hose and securely fasten the clamp (3).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 50 N·m (37 lb ft).
Tighten
Tighten the bolt to 10 N·m (89 lb in).
Tighten
| • | Tighten the bolts (1) to 50 N·m (37 lb ft). |
| • | Tighten the bolt (2) to 30 N·m (22 lb ft). |
Tighten
Tighten the bolt to 10 N·m (89 lb in).
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Install the coolant crossover pipe assembly onto the engine.
- Install the engine lift bracket (1) and the front coolant crossover pipe bolts (3). Tighten the bolts to 50 N·m (37 lb ft).
- Install the side coolant crossover pipe bolt (2) and tighten to 10 N·m (89 lb in).
- Install the idler pulleys and bolts.
- Install the coolant vent pipe and bolt (2) and tighten to 10 N·m (89 lb in).
- Install the heater inlet/outlet pipe and bolt (1) and tighten to 10 N·m (89 lb in).
- Install the thermal bypass hose and securely fasten the clamp (3).
Caution: Refer to Fastener Caution in the Preface section.
| • | Tighten the bolts (1) to 50 N·m (37 lb ft). |
| • | Tighten the bolt (2) to 30 N·m (22 lb ft). |
