Special Tools

J 45059 Angle Meter

1. Apply sealer GM P/N 12378521, (Canadian P/N 88901148) or the equivalent to both sides of the crankshaft rear main bearing cap (1). Press sealer into gap using a putty knife.



2. Apply sealer GM P/N 12378521 (Canadian P/N 88901148) or equivalent to both sides of the front cover/block mating area (1).



3. Install the oil pan gasket.
4. Install the oil pan.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the oil pan bolts.

Tighten
Tighten the oil pan bolts to 25 N·m (18 lb ft).

6. Apply sealer GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the oil pan side bolt threads.
7. Install the oil pan side bolts.

Tighten

1. Tighten the oil pan side bolts a first pass to 50 N·m (37 lb ft).
2. Tighten the oil pan side bolts a second pass to 50 degrees using the J 45059 .



8. Install the oil pan drain plug.

Tighten
Tighten the oil pan drain plug to 25 N·m (18 lb ft).

Special Tools

J 45059 Angle Meter

For equivalent regional tools, refer to Special Tools

1. Apply sealer GM P/N 12378521, (Canadian P/N 88901148) or the equivalent to both sides of the crankshaft rear main bearing cap (1). Press sealer into gap using a putty knife.



2. Apply sealer GM P/N 12378521 (Canadian P/N 88901148) or equivalent to both sides of the front cover/block mating area (1).



3. Install the oil pan gasket.
4. Install the oil pan.

Caution: Refer to Fastener Caution in the Preface section.

5. Install the oil pan bolts and tighten to 25 N·m (18 lb ft).
6. Apply sealer GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the oil pan side bolt threads.
7. Install the oil pan side bolts.
8. Tighten the oil pan side bolts a first pass to 50 N·m (37 lb ft).
9. Tighten the oil pan side bolts a second pass to 50 degrees using the J 45059 meter .



10. Install the oil pan drain plug and tighten to 25 N·m (18 lb ft).