GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Captiva Sport 🢒 Engine 🢒 Engine Mechanical - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Cylinder Head Installation - Right Side

Tools Required

J 45059 Angle Meter

  1. Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.

    2. Object Number: 902817 Size: SH
  2. Install a NEW right cylinder head gasket using the deck face locating pins for retention.

    3. Object Number: 902818 Size: SH
  3. Align the right cylinder head with the deck face locating pins.
  4. Place the right cylinder head in position on the deck face.

    5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 2126651 Size: SH

    Important: DO NOT allow oil on the cylinder head bolt bosses.

    Important: DO NOT reuse the old cylinder head bolts.

  5. Install the NEW M11 cylinder head bolts (1).

    6. Tighten

    1. Tighten the M11 cylinder head bolts a first pass in sequence to 30 N·m (22 lb ft).
    2. Tighten the M11 cylinder head bolts a second pass in sequence an additional 150 degrees using the J 45059 .
  6. Install the NEW M8 cylinder head bolt (2).

    7. Tighten

    1. Tighten the M8 cylinder head bolt a first pass to 15 N·m (11 lb ft).
    2. Tighten the M8 cylinder head bolt a second pass an additional 75 degrees using the J 45059 .

Special Tools

J 45059 Angle Meter

For equivalent regional tools, refer to Special Tools.

  1. Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.

    2. Object Number: 902817 Size: SH
  2. Install a NEW right cylinder head gasket using the deck face locating pins for retention.

    3. Object Number: 902818 Size: SH
  3. Align the right cylinder head with the deck face locating pins.
  4. Place the right cylinder head in position on the deck face.

    5. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 2126651 Size: SH

    Note: 

       • DO NOT allow oil on the cylinder head bolt bosses.
       • DO NOT reuse the old cylinder head bolts.

  5. Install the NEW M11 cylinder head bolts (1).
    6. 5.1. Tighten the M11 cylinder head bolts a first pass in sequence to 30 N·m (22 lb ft).
    5.2. Tighten the M11 cylinder head bolts a second pass in sequence an additional 150 degrees using the J 45059 angle meter .
  6. Install the NEW M8 cylinder head bolt (2).
    7. 6.1. Tighten the M8 cylinder head bolt a first pass to 15 N·m (11 lb ft).
    6.2. Tighten the M8 cylinder head bolt a second pass an additional 75 degrees using the J 45059 angle meter .