For 1990-2009 cars only
Removal Procedure
- Drain the fuel tank until the level in the tank is less than 1/4 full. Refer to Fuel Tank Draining.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove the fuel fill cap.
- Remove the fuel tank fill pipe housing to fuel tank fill pipe screws (1).
- Remove the right rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement.
- Remove the fuel fill pipe upper bracket nut (1).
- Disconnect the fill pipe vent line quick connect fitting (4) from the fuel tank fresh air line (3). Refer to Plastic Collar Quick Connect Fitting Service.
- Disconnect the fuel tank vapor line quick connect fitting (2) from the fill pipe recirculation line (5). Refer to Plastic Collar Quick Connect Fitting Service.
- Loosen the fuel fill pipe hose clamp (1) at the fuel tank.
- Remove the fuel fill pipe (6) from the fuel tank.
Installation Procedure
- Install the fuel fill pipe (6) to the fuel tank.
- Tighten the fuel fill pipe hose clamp (1) to 5 N·m (44 lb in)at the fuel tank.
- Connect the fuel tank vapor line quick connect fitting (2) to the fill pipe recirculation line (5). Refer to Plastic Collar Quick Connect Fitting Service.
- Connect the fill pipe vent line quick connect fitting (4) to the fuel tank fresh air line (3). Refer to Plastic Collar Quick Connect Fitting Service.
- Install the fuel fill pipe upper bracket nut (1) to 4 N·m (35 lb in).
- Install the right rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement.
- Install the fuel tank fill pipe housing to fuel tank fill pipe screws (1) and tighten to 10 N·m (89 lb in).
- Install the fuel fill cap.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
Note: Ensure that the notch in the fuel fill pipe hose aligns with the locating tab on the fuel tank.
Caution: Refer to Fastener Caution in the Preface section.
