GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Captiva Sport 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Removal Procedure

    Object Number: 1889266 Size: SH
  1. Remove the engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side .
  2. Disconnect the engine wiring harness electrical connector (1) from the bank 2 intake camshaft position (CMP) sensor (8).

    3. Object Number: 1285241 Size: SH
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.

Installation Procedure

    Object Number: 1285241 Size: SH
  1. Install the CMP sensor.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the CMP sensor bolt.

    3. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1889266 Size: SH
  3. Connect the engine wiring harness electrical connector (1) to the bank 2 intake CMP sensor (8).
  4. Install the engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side .

Removal Procedure

    Object Number: 1889266 Size: SH
  1. Remove the engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side.
  2. Disconnect the engine wiring harness electrical connector (1) from the bank 2 intake camshaft position (CMP) sensor (8).

    3. Object Number: 1285241 Size: SH
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.

Installation Procedure

    Object Number: 1285241 Size: SH
  1. Install the CMP sensor.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the CMP sensor bolt. Tighten the bolt to 10 N·m (89 lb in).

    3. Object Number: 1889266 Size: SH
  3. Connect the engine wiring harness electrical connector (1) to the bank 2 intake CMP sensor (8).
  4. Install the engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side.