GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Captiva Sport 🢒 Suspension 🢒 Front Suspension 🢒 Lower Control Arm Ball Joint Replacement

Removal Procedure

    Object Number: 933745 Size: SH
  1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
  2. Place the control arm in a vise or suitable holding device.
  3. Remove the ball joint rivets using the following procedure.
    4. 3.1. Drill through the rivets using a 8 mm (5/16 in) drill bit.
    3.2. Enlarge the hole using a 12 mm (31/64 in) drill bit.
    3.3. Remove any remaining burs from the control arm.
  4. Remove the ball joint from the control arm. Note the position of the ball joint for reassembly.

Installation Procedure

    Object Number: 933754 Size: SH

    Important: The control arm must be clean and free of debris.

  1. Install the ball joint to the control arm as previously noted.

    2. Notice: Refer to Fastener Notice in the Preface section.

    Important: 

       • Only use hardware provided with the new ball joint.
       • The bolts must be installed with the bolt head on top of the ball joint.

  2. Install the ball joint to control arm bolts.

    3. Tighten
    Tighten the bolts and nuts to 68 N·m (50 lb ft).

  3. Install the lower control arm. Refer to Lower Control Arm Replacement .

Removal Procedure

    Object Number: 933745 Size: SH
  1. Remove the lower control arm. Refer to Lower Control Arm Replacement.
  2. Place the control arm in a vise or suitable holding device.
  3. Remove the ball joint rivets using the following procedure.
    4. 3.1. Drill through the rivets using a 8 mm (5/16 in) drill bit.
    3.2. Enlarge the hole using a 12 mm (31/64 in) drill bit.
    3.3. Remove any remaining burs from the control arm.
  4. Remove the ball joint from the control arm. Note the position of the ball joint for reassembly.

Installation Procedure

    Object Number: 933754 Size: SH

    Note: The control arm must be clean and free of debris.

  1. Install the ball joint to the control arm as previously noted.

    2. Caution: Refer to Fastener Caution in the Preface section.

    Note: 

       • Only use hardware provided with the new ball joint.
       • The bolts must be installed with the bolt head on top of the ball joint.

  2. Install the ball joint to control arm bolts and tighten the bolts/nuts to 68 N·m (50 lb ft).
  3. Install the lower control arm. Refer to Lower Control Arm Replacement.