Replace the wheel if any of the following conditions exist:
| • | The wheel exhibits excessive runout |
| • | The wheel is severely rusted |
| • | The wheel is severely corroded |
| | Important: Air leaks caused by porosity on aluminum wheels are repairable.
|
Caution: If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the
wheel bolt(s), install only new Saturn original equipment parts. Installation of used
parts or non-Saturn original equipment parts may cause the wheel to loosen, loss of
tire air pressure, poor vehicle handling and loss of vehicle control resulting in
personal injury.
Notice: The use of non-GM original equipment wheels may cause:
| • | Damage to the wheel bearing, the wheel fasteners and the wheel |
| • | Tire damage caused by the modified clearance to the adjacent vehicle components |
| • | Adverse vehicle steering stability caused by the modified scrub radius |
| • | Damage to the vehicle caused by the modified ground clearance |
| • | Speedometer and odometer inaccuracy |
Replace the wheel, the wheel studs and the wheel/nuts, or the wheel bolts if
applicable, if any of the following conditions exist:
| • | The wheel has elongated bolt holes. |
| • | The wheel/nuts, or bolts if applicable, loosen repeatedly. |
Steel wheel identification is stamped into the wheel near the valve stem.
Aluminum wheel identification is cast into the inboard side of the wheel.
Replace the wheel if any of the following conditions exist:
| • | The wheel exhibits excessive runout |
| • | The wheel is severely rusted |
| • | The wheel is severely corroded |
| | Note: Air leaks caused by porosity on aluminum wheels are repairable.
|
Warning: If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the wheel bolt(s), install only new Saturn original equipment parts. Installation of used parts or non-Saturn original
equipment parts may cause the wheel to loosen, loss of tire air pressure, poor vehicle handling and loss of vehicle control resulting in personal injury.
Caution: The use of non-GM original equipment wheels may cause:
| • | Damage to the wheel bearing, the wheel fasteners and the wheel |
| • | Tire damage caused by the modified clearance to the adjacent vehicle components |
| • | Adverse vehicle steering stability caused by the modified scrub radius |
| • | Damage to the vehicle caused by the modified ground clearance |
| • | Speedometer and odometer inaccuracy |
Replace the wheel, the wheel studs and the wheel/nuts, or the wheel bolts if applicable, if any of the following conditions exist:
| • | The wheel has elongated bolt holes. |
| • | The wheel/nuts, or bolts if applicable, loosen repeatedly. |
Steel wheel identification is stamped into the wheel near the valve stem.
Aluminum wheel identification is cast into the inboard side of the wheel.
