Case Cover Assembly Installation. Chevrolet Captiva Sport 2009

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Captiva Sport 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 6T70/6T75 🢒 Case Cover Assembly Installation

Callout	Component Name
1	Input Shaft Thrust Bearing Tip Note location of the orientation lip on bearing. All thrust bearings can only be assembled one way.
2	A/Trans Case Cover Gasket
3	Input Speed Sensor Wire Harness Tip Route the input speed sensor wire harness through the case passage.
4	A/Trans Case Cover Assembly Procedure Use guide pins to install the case cover assembly to prevent damage to the input shaft thrust bearing. Pull the input speed sensor wire harness through the case passage while lowering the cover assembly onto the case. Special Tools J 39068 Guide Pins
5	A/Trans Case Cover Assembly Bolt M6 x 30 (Qty: 10) Notice: Refer to Fastener Notice in the Preface section. Procedure Tighten in sequence shown. Tighten 12 N·m (9 lb ft)

Callout	Component Name
1	Input Shaft Thrust Bearing Tip Note location of the orientation lip on bearing. All thrust bearings can only be assembled one way.
2	A/Trans Case Cover Gasket
3	Input Speed Sensor Wire Harness Tip Route the input speed sensor wire harness through the case passage.
4	A/Trans Case Cover Assembly Procedure Use guide pins to install the case cover assembly to prevent damage to the input shaft thrust bearing. Pull the input speed sensor wire harness through the case passage while lowering the cover assembly onto the case. Special Tools 39068 Guide Pins For equivalent regional tools, refer to Special Tools.
5	A/Trans Case Cover Assembly Bolt M6 x 30 (Qty: 10) Caution: Refer to Fastener Caution in the Preface section. Procedure Tighten in sequence shown. Tighten 12 N·m (9 lb ft)