Front Fender Wheel Opening Molding Replacement. Chevrolet Captiva Sport 2009

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Captiva Sport 🢒 Body Hardware and Trim 🢒 Exterior Trim 🢒 Front Fender Wheel Opening Molding Replacement

Callout	Component Name
Preliminary Procedure Remove either the LF or RF wheelhouse liner. Refer to Front Wheelhouse Liner Replacement Remove the inner front wheel opening molding nut. Release the retainers from the wheelhouse. Release the front wheel opening molding from the front edge of the lower rocker panel molding. Remove the front wheel opening molding from the vehicle.
1	Front Fender Wheel Opening Molding Nut Tip Loosen the rear bolt at the rear of the front bumper fascia securing the fender flange to the front bumper fascia. Notice: Refer to Fastener Notice in the Preface section. Tighten 4.0 N·m (35 lb in)
2	Front Fender Wheel Opening Molding Retainer (Qty: 6) Tip Replace any broken retainers upon re-assembly.
3	Front Fender Wheel Opening Molding Assembly

Callout	Component Name
Preliminary Procedures Remove either the LF or RF wheelhouse liner. Refer to Front Wheelhouse Liner Replacement. Remove the inner front wheel opening molding nut. Release the retainers from the wheelhouse. Release the front wheel opening molding from the front edge of the lower rocker panel molding. Remove the front wheel opening molding from the vehicle.
1	Front Fender Wheel Opening Molding Nut Caution: Refer to Fastener Caution in the Preface section. Tip Loosen the rear bolt at the rear of the front bumper fascia securing the fender flange to the front bumper fascia. Tighten 4.0 N·m (35 lb in)
2	Front Fender Wheel Opening Molding Retainer (Qty: 6) Tip Replace any broken retainers upon re-assembly.
3	Front Fender Wheel Opening Molding Assembly