Ignition and Start Switch Housing Replacement. Chevrolet Captiva Sport 2009

GM Service Manual Online

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Captiva Sport 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Ignition and Start Switch Housing Replacement

Object Number: 1867489 Size: MF

Callout	Component Name
Preliminary Procedure Remove the turn signal switch bracket. Refer to Turn Signal Switch Bracket Replacement.
1	Ignition/Start Switch Housing Bolt Notice: Refer to Fastener Notice in the Preface section. Procedure Use a small chisel and hammer to back out the ignition/start switch housing bolt counterclockwise and remove it. When installing a new ignition/start switch housing bolt continue to tighten it until the head shears off.
2	Ignition/Start Switch Housing Strap
3	Ignition/Start Switch Housing Procedure Disconnect any electrical connectors as needed. Tip The ignition lock cylinder must be turned to the run position in order to remove and/or install the ignition/start switch housing.

Ignition and Start Switch Housing Replacement With Electronic Power Steering

Object Number: 1867489 Size: MF

Callout	Component Name
Preliminary Procedure Remove the turn signal switch bracket. Refer to Turn Signal Switch Bracket Replacement.
1	Ignition and Start Switch Housing Bolt Caution: Refer to Fastener Caution in the Preface section. Procedure Use a small chisel and hammer to back out the ignition and start switch housing bolt counterclockwise and remove it. When installing a new ignition and start switch housing bolt continue to tighten it until the head shears off.
2	Ignition and Start Switch Housing Strap
3	Ignition and Start Switch Housing Procedure Disconnect any electrical connectors as needed. Turn the ignition lock cylinder to the run position in order to remove and install the ignition and start switch housing.

Ignition and Start Switch Housing Replacement With Hydraulic Power Steering

Object Number: 2148091 Size: MF

Callout	Component Name
Preliminary Procedure Remove the turn signal switch bracket. Refer to Turn Signal Switch Bracket Replacement.
1	Ignition and Start Switch Housing Bolt (Qty: 2) Caution: Refer to Fastener Caution in the Preface section. Procedure Use a small chisel and hammer to back out the ignition and start switch housing bolt counterclockwise and remove it. When installing new ignition and start switch housing bolts continue to tighten them until the heads shear off.
2	Ignition and Start Switch Housing Strap
3	Ignition and Start Switch Housing Procedure Disconnect any electrical connectors as needed. Turn the ignition lock cylinder to the run position in order to remove and install the ignition and start switch housing.