Engine Flywheel Installation Manual Transmission

Special Tools

J 45059 Angle Meter

1. Install the clutch pilot bearing.
2. Install the flywheel/pressure plate.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the flywheel/pressure plate bolts.

Tighten
Tighten the flywheel/pressure plate bolts to 50 N·m (37 lb ft) plus an additional 70 degrees using the J 45059 .

Engine Flywheel Installation Automatic Transmission

1. Install the flywheel.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the flywheel bolts.

Tighten
Tighten the flywheel bolts to 70 N·m (52 lb ft).

Engine Flywheel Installation Automatic Transmission

1. Install the flywheel.

Caution: Refer to Fastener Caution in the Preface section.

2. Install the flywheel bolts and tighten to 70 N·m (52 lb ft).

Engine Flywheel Installation Manual Transmission

Special Tools

J 45059 Angle Meter

For equivalent regional tools, refer to Special Tools

1. Install the clutch pilot bearing.
2. Install the flywheel/pressure plate.

Caution: Refer to Fastener Caution in the Preface section.

3. Install the flywheel/pressure plate bolts and tighten to 50 N·m (37 lb ft) plus an additional 70 degrees using the J 45059 meter .